LENS CHANGING INSTRUCTIONS

Aethon Crystal Blue Clarion Blue Front

AETHON

Alliant Race Neon Smoke Front

ALLIANT

Dolomite 2.0 Metallic Silver Water Repelling sunglass front

DOLOMITE 2.0

kilo crystal smoke clarion interchange sunglass front

KILO

podium matte black clarion red cycling sunglass

PODIUM

podium xc matte crystal clarion red cycling sunglass front

PODIUM XC

rail crystal blue clarion blue cycling sunglass front

RAIL

rail xc crystal smoke front

RAIL XC

Shutout Midnight navy youth sport sunglass front

SHUTOUT

Sledge sport sunglass in crystal red with clarion yellow lens

SLEDGE

Sledge Lite sport sunglass in crystal smoke with clarion blue lens

SLEDGE LITE

STASH

Front view of the Tsali Gunmetal Red model with Clarion Red lens.

TSALI

Tyrant 2 Gunmetal fototec

TYRANT 2.0

veloce matte black brown

VELOCE

WASP

wisp midnight blue front view

WISP

Small Parts Instructions

Ear Piece: Remove old ear pad and clean the surface with rubbing alcohol. Slip the ear pad over the nub at the end of the arm piece and secure.

Ear Piece (with glue): Remove old ear pad and clean the surface with rubbing alcohol. Dot exposed surface with superglue (we recommend super glue gel to avoid spills.) Firmly press the new parts into the frame until glue sets. For an ear pad with metal stem: Dot stem with glue. Slide the new ear pad on until it meets the frame. Let the glue set completely before wearing.

Nose Piece (with glue): Remove old nose pad. Clean surface with rubbing alcohol. Dot exposed surface with superglue (we recommend super glue gel to avoid spills.) Firmly press new parts into frame until glue sets. Let glue set completely before wearing.

Nose Piece (screwed): Using a screwdriver, remove the old nose piece and screw. Use a screwdriver to put the nose piece in place with replacement screw(s). Please be sure not to over tighten or strip the screw while replacing. Screwdriver must be 0 in size. Some models will have two screws to hold the nose piece in place.

Nose Piece (shield snap-in): Remove old nose pad by rotating down from brow of the sunglass. Insert new nose pad into opening. Support the back of the nose bracket with finger and push nose pad into place.

Rx Adaptor: Tifosi RX03A optical insert is available for only compatible Tifosi models. Remove nosepiece. With lens back facing you, firmly grasp lens with one hand. Using opposite hand, grip nosepiece & gently twist clockwise down and away from lens until it releases. Install RX03A adaptor. Holding lens firmly with one hand, use opposite hand to guide RX03A adaptor’s nosepiece into notch on lens. With nose pads oriented correctly, gently push adaptor towards notch in lens until it snaps into place.

Sweat, UV rays, cleaners and other chemicals can cause rubber parts to breakdown over prolonged periods of exposure.